Auto-adjust grid not working?

majoch · 07-01-2018, 10:28 AM

Hello,

Weird issue that I can't seem to work out.

I'm at the final stages of completing a model for my Portland franchise and I can't get the auto-alignment to work.

When I select the bases in the 3D model the fences aromatically align at almost a ninety-degree angle?

https://imgur.com/a/u1BePL9

Any assistance would be greatly appreciated.

eriqjaffe · 07-01-2018, 05:42 PM

Are you doing this, too?

majoch · 07-01-2018, 09:25 PM

Hey,

Yeah, I am; that's the weird thing. I place all three dots (like so) and the grid turns up way below the "ground" of the model and off to the left, as in the first picture.

eriqjaffe · 07-01-2018, 11:22 PM

Huh. Not sure, then. Maybe silvam might know something.

majoch · 07-02-2018, 05:04 AM

I fixed this issue through a lot of trial and error; I'm not sure exactly what step fixed the issue but I did the following.

- copied my model piece by piece into a new file. (ie, not Ctrl+A & Ctrl + C)
- Deleted any parts of the model that were below the axes, raising the whole thing by a few inches.
- De-Grouped everything.

07-01-2018, 10:28 AM	#1
majoch Minors (Rookie Ball) Join Date: Jun 2018 Posts: 22	Auto-adjust grid not working? Hello, Weird issue that I can't seem to work out. I'm at the final stages of completing a model for my Portland franchise and I can't get the auto-alignment to work. When I select the bases in the 3D model the fences aromatically align at almost a ninety-degree angle? https://imgur.com/a/u1BePL9 Any assistance would be greatly appreciated.

07-01-2018, 05:42 PM	#2
eriqjaffe Hall Of Famer Join Date: May 2003 Location: Under The Christmas Fish Posts: 7,640	Are you doing this, too? __________________

07-01-2018, 11:22 PM	#4
eriqjaffe Hall Of Famer Join Date: May 2003 Location: Under The Christmas Fish Posts: 7,640	Huh. Not sure, then. Maybe silvam might know something. __________________

07-01-2018, 09:25 PM	#3
majoch Minors (Rookie Ball) Join Date: Jun 2018 Posts: 22	Hey, Yeah, I am; that's the weird thing. I place all three dots (like so) and the grid turns up way below the "ground" of the model and off to the left, as in the first picture.

07-02-2018, 05:04 AM	#5
majoch Minors (Rookie Ball) Join Date: Jun 2018 Posts: 22	I fixed this issue through a lot of trial and error; I'm not sure exactly what step fixed the issue but I did the following. - copied my model piece by piece into a new file. (ie, not Ctrl+A & Ctrl + C) - Deleted any parts of the model that were below the axes, raising the whole thing by a few inches. - De-Grouped everything.